Protective Measures for Finished Products of Honeycomb Aluminum Plate

In addition to the protection of materials entering the site and finished Products, as well as semi-finished Products and auxiliary accessories, semi-finished Products and finished Products that have been installed or piled up on each floor are also required to beHoneycomb aluminum plateThe finished product is subject to strict protection measures, so the following requirements have been formulated in particular:

1. During the secondary handling in the field, collision and deformation are not allowed. The starting and stopping should be light and the supporting pad should be stable during manual handling to prevent sliding and dumping. During vertical transportation, the lifting should run slowly. When descending to the platform, care should be taken not to collide with the building.

2. In addition to neatly stacking materials on site, fences and eye-catching signs need to be pulled up to prevent collision or pollution. Isolation and protection fences shall be set up for storage on the floor, and eye-catching signs shall be provided, and the materials shall be placed in places where secondary handling is not required as far as possible.

3.ceramic honeycomb plateThe curtain wall that has been installed should also be equipped with protective signs, and other construction personnel on the site should be notified to pay attention to the protection of the finished product, and at the same time stick tape on the surface to protect it.

4. The main parts and auxiliary parts of the curtain wall to be installed shall be kept clean at any time. If there are any adherents, they shall be removed at any time. Before the work is completed, if the interior decoration personnel enter the site for construction, a protection disclosure shall be provided, and protective measures and matters needing attention shall be proposed.

5. For the protection of finished Products, in addition to the installation personnel to pay attention to protection during installation, special personnel should be set up to take care of them. The handover of processes must have process handover procedures. For example, after installation is in place,arc honeycomb panelThe handover of welding process and anti-rust paint process shall have handover procedures, and the construction process of closing the gusset plate after the installation of fire-proof cotton shall have handover procedures, etc.

6. The inspection of the hierarchical flow of nursing personnel shall not only record the problems found, but also report them to the quality department for timely treatment at any time.

Recommended:Main Technical Measures of Honeycomb Aluminum Plate Construction Preparation for Fabrication of Outdoor Honeycomb Aluminum Curtain Wall