China's earliest production and processing of aluminum veneer ceiling, one of the curtain wall manufacturers
The technical measures of honeycomb aluminum plate are mainly divided into the following points.
The 1. shall strengthen the quality inspection and management of raw materials, semi-finished Products and components. The materials used must have factory certificate and quality guarantee certificate. The materials must be subject to quality acceptance when entering the site, and must be approved and signed by the owner and supervision engineer. Unqualified materials, semi-finished Products and components shall not enter the construction site and shall not be used in the project.
Before entering the site, the 2. embedded parts shall be subjected to pull-out test first. According to the test report, the materials shall be determined. When the aluminum frame is processed, it shall be tested in time in strict accordance with the processing and assembly requirements. After the samples are made, they shall be immediately sent to the national accreditation testing organization for testing the basic performance of wind pressure deformation resistance, air penetration resistance, rainwater leakage resistance and so on.
3.Honeycomb aluminum plateFor the operation of various types of work, the operation post responsibility system should be established. The main types of work should implement the model listing system and strictly follow the construction process card. This is also the technical measure of honeycomb aluminum plate.
4. to the seasonal construction measures of honeycomb aluminum plate, the curtain wall construction will be affected by seasonal wind and snow, rain and low temperature.
5.ceramic honeycomb plateAt the time of installation, the wind force exceeds five, fog and thunderstorm weather shall not be installed.
The main process that 6. rain will affect the curtain wall is gluing. In case of moderate to heavy rain, all construction should be stopped. In case of light rain, single elements and curtain wall skeleton can be installed. The welding points should be protected from rain. After welding, the welding points should be tightly covered and not wet. In addition, the welding points should be prevented from being cooled by water and affecting the quality of the welding lines.
7. low temperatures do not exceed minus 5 degrees,Stone Honeycomb PanelConstruction can be carried out as usual, and the operation must be stopped when it exceeds.
8. the filing work of technical data should be in accordance with the requirements of technical files, timely fill in, collect and review the data, organize and establish complete engineering technical files, and submit them to the owner for filing in time.
Recommended:Protective Measures for Finished Products of Honeycomb Aluminum Plate