Honeycomb aluminum plate requires ultra-high installation technology

hyperboloidHoneycomb aluminum plate的加工与安装。质轻装饰铝合金Honeycomb Panel厚度一般为8mm 、10mm、12mm、15mm、20mm、25mm、35mm、50mm. The weight of the plate per square meter is approximately4.5～8KG(Different thickness different weight)The load-bearing load of the building is greatly reduced. The test is carried out in the factory and on the site. On the basis of obtaining reliable data and parameters, and on the basis of realizing fine measurement, the single processing is carried out to ensure the positioning quality of aluminum purlin.

(1) Measuring and setting out: according to the three-dimensional coordinates provided by the design, set out the coordinates of the panel on the aluminum purlin, and set out the position of the plate seam on the aluminum purlin.

(2) Cutting and processing: honeycomb panels are processed and produced by professional manufacturers and inspected and accepted by the project department.

(3) Transportation and hoisting of honeycomb panels:Transport the honeycomb panel to the corresponding lifting position by means of transportation such as trolley;At the position of the inner ring gutter, erect the hoisting pulley, pull it to the roof by manpower, and transport it to the designated position of installation.;Both ends of the hoisted honeycomb panel shall be tied with a lockwire rope.

(4) Positioning and Installation of Honeycomb Panel:Install the honeycomb panel on the purlin and align the seam according to the setting-out position.;The installation can be installed by auxiliary tools such as ladders and ropes.;The dust and dirt should be wiped clean before installation, and the protective film of the plate seam is strictly prohibited to be opened at this time to protect the honeycomb aluminum plate surface. The scoring grid map puts the honeycomb aluminum plate at that location.(Honeycomb aluminum panels are marked)Hang on the profile hook and adjust it“three degrees”。

在安装过程中，做好产品保护，杜绝因划伤等原因造成的返工。Honeycomb aluminum plate周围用于加劲肋连接在一起的角码与框架梁铆接。同一平台的符合Honeycomb aluminum plate平整度要控制在3 mmWithin, the width error of the caulking is also controlled.2 mmWithin. During the construction, protective measures shall be taken for the components and panels of the curtain wall, and the adhesion on the surface shall be removed in time after the sealant is cured and reaches the required strength.

Honeycomb aluminum plate表面平整铝合金Honeycomb Panel平面度误差在±1mmWithin, the distinctive ultra-flat effect is due to the ultra-high installation technology.

Recommended article:

The advantages of honeycomb aluminum plate

/Article/fengwolvbandegexiang_1.html

Installation details of honeycomb aluminum panels

/Article/fengwolvbandeanzhuan_1.html

Research and Development of New Hanging Technology for Aluminum Honeycomb Panel

/Article/xinxinglvfengwobangu_1.html