Installation and High Strength of Honeycomb Aluminum Plate

　　(1) Honeycomb Aluminum Panel Installation, willHoneycomb aluminum plateTear off the folding part of the protective film, stick masking paper at the folding part of the 90-degree corner, the masking paper shall be folded at the corner glue seam by 90-degree corner, the masking paper of the whole plate shall be in place at one time, and the installation of honeycomb aluminum plate shall be smoothed with force to avoid wrinkling of the masking paper.

(2) Fill the foam rod, which is required to be dense and straight.

(3) When injecting glue, walk in a straight line, from top to bottom, from left to right, and finish at one time.

(4) When scraping glue, the glue injection step should be carried out once to the end. The installation of honeycomb aluminum plate at the corner is slightly slower.

(5) Tear off the masking paper into an outward 45 ° tilt pull, should be torn off masking paper centralized processing, to avoid environmental pollution.

The installation of honeycomb aluminum plate is made of high-strength alloy aluminum plate as the surface, bottom plate and aluminum honeycomb core by high temperature and high pressure composite. It is a kind of composite plate, which uses honeycomb sandwich structure. The installation of honeycomb aluminum plate is excellent in material selection, advanced technology and reasonable structure, and has great advantages in color, flatness and so on.

Installation of honeycomb aluminum plate The installation of the column shall first connect the column with the connecting piece, and then connect the connecting piece with the embedded part of the main body, and adjust and fix it. The installation elevation deviation of two adjacent columns shall not be greater than 3mm, the maximum elevation deviation of the installation of honeycomb aluminum plates on the same layer of columns shall not be greater than 5mm, and the distance deviation of two adjacent columns shall not be greater than 2mm. The elevation deviation of column installation shall not be greater than 3mm, the front and rear deviation of axis shall not be greater than 2mm, and the left and right deviation shall not be greater than 3mm.