Aluminum honeycomb panel installation construction

aluminum honeycomb panel工程施工要求精度很高，在进行aluminum honeycomb panel安装之前，必须由基准轴线和水准点重新测量，并校正复核。测量时应控制分配测量误差，不能使误差积累。

The aluminum honeycomb panel shall be installed in place according to the number on the plate distribution diagram, and the plane size of each plate shall be determined. After the cutting of the aluminum honeycomb panel is completed, the surrounding of the plate shall be sealed with matching aluminum sleeve wire, and then hoisted and fixed.

吊装过程中对面板半成品进行保护，防止划伤，板材就位后将横竖分格缝间隙控制在30 ~40mmAfter trial installation, check its levelness, verticality and split seam width. After on-site inspection is qualified, use stainless steel bolts to fix the panel on the keel.

Aluminum honeycomb panel is composed of two very thin aluminum plate sandwiched by a layer of honeycomb core, because the area of the honeycomb core solid part is very small, so the overall quality of the honeycomb panel is very light.

In addition, it also has many advantages such as high specific strength and specific stiffness, heat insulation and sound insulation, so it has been widely used in the fields of aerospace, trains and ships. In this paper, the preparation technology of aluminum honeycomb panel is reviewed.

Recommended article:

Selection of aluminum honeycomb panels for house decoration

/Article/fangwuzhuangxiulvfen_1.html

Type of surface material used for honeycomb aluminum sheet metal wall

/Article/fengwolvbanjinshuqia_1.html

Mechanical Properties of Aluminum Honeycomb Panel

/Article/lvfengwobandelixuexi_1.html