Stone aluminum honeycomb panel detailed introduction

             以横平竖直原则标识立挺与横梁中心轴线，按设计胶缝调整弯弧板，将整个单元柱子包完，再作整体较正，保证上下分格、垂直与平整度误差在2毫米，将所有螺丝补齐。   Stone aluminum honeycomb panel detailed introduction

       1、Stone aluminum honeycomb panel detailed introductionTear off the hem part of the protective film on the aluminum honeycomb panel, and press90 °Stick masking paper at the corner hem. Mic paper inThe joint of the word glue shall be folded90 °Corner, the whole plate masking paper once in place, hard sweep flat, avoid masking paper crease.

              
 　 2、aluminum honeycomb panelPacking foam round beech, required to be dense and straight.

 
 　 3./span>、灌胶时按直线走，从上至下，从左至右，一次打完。

 　 4、aluminum honeycomb mesh plateScraping glue according to the principle of glue injection should also be once to the end, inSlightly slower at the word interface.

 　 5Tear off the masking paper and become extroversed.45 °Tilt and pull to concentrate the torn masking paper into the dustbin to avoid environmental pollution.

 　 6After the weather-resistant adhesive dries, tear off the outer protective film when sweeping the tail, and wipe off the dust around with a dry cloth.

Second, there are several kinds of stone aluminum honeycomb panels

　1.Texture honeycomb boardChange all irregular hand drawingsAUTO CADDrawing, after confirmation, print three copies and bind them into a book according to batch and drawing number. Technology(Transfer to archive room after completion)One copy, one copy for workshop and one copy for quality assurance inspection.2.Drawings without aluminum honeycomb panel numbering shall be uniformly numbered. Further numbering of numbered figure numbers: suffixARepresentative Panel;SuffixBRepresentative baseplate;SuffixCOn behalf of aluminum honeycomb core;And so on.

　  3.For the aluminum plate or other material surface and bottom plate that needs sheet metal processing, the bending coefficient should be carefully measured and documented.

   4.Write a catalog, calculate the area and total area of a single piece, and so on.

    5.For the plate to be processed by sheet metal, the unfolded drawing of sheet metal shall be drawn according to the bending coefficient and the size shall be indicated. If the inner and outer surfaces are not marked on the drawing, the expanded drawing will be drawn after implementation.

       6.对需进行数控下料和数控开展开料的，要进行计算机编程，并存入UThe disk and other technical data shall be submitted to the workshop director for signature.

第三、Stone aluminum honeycomb panel construction line

11. The verticality of the structural column shall be correct, hang the vertical line on the keel installation axis, measure the upper and lower points with an angle ruler, record the data, and enlarge the average value.10mm.

　　2Mark the axis position on the floor with red and blue pencil, and use an angle ruler90 °The extension lead is drawn out, and the relative position keel axis is determined. The correction error is the same as above.

       3.When the aluminum coil is formed, the coating color is attached to the above technology, the coating adhesion is strong, the durability is good, the color is uniform, and the Products of the same batch basically do not have any color difference.

Recommended Articles