Stone aluminum honeycomb board hanging board

aluminum honeycomb panel以横平竖直原则标识立挺与横梁中心轴线，按设计胶缝调整弯弧板，将整个单元柱子包完，再作整体较正，保证上下分格、垂直与平整度误差在2毫米，将所有螺丝补齐。

Glue and clean stone aluminum honeycomb panel

1. Tear off the folding part of the protective film on the aluminum honeycomb panel, and stick masking paper at the folding part of the 90-degree corner. The masking paper shall be folded into a 90-degree corner at the glue seam of the word . The masking paper of the whole plate shall be in place at one time and shall be swept flat with force to avoid wrinkling of the masking paper.

2, filling foam round beech, requiring dense and straight.

3. When filling glue, walk in a straight line, from top to bottom, from left to right, and finish at one time.

4, scraping glue according to the principle of glue injection should also be once to the end, at the word interface scraping speed is slightly slower.

5, tear off the masking paper, into an outward 45 degree tilt pull, the torn masking paper concentrated in the dustbin, to avoid environmental pollution.

6. After the weather-resistant adhesive dries, tear off the outer protective film when sweeping the tail, and wipe off the dust around with a dry cloth.

Recommended article:

Structure and use of honeycomb aluminum plate

/Article/fengwolvbandegouzaoh_1.html

Development Trend of Aluminum Honeycomb Panel

/Article/lvfengwobandefazhanq_1.html

Processing conditions of honeycomb aluminum plate

/Article/fengwolvbandejiagong_1.html