Straightening of aluminum honeycomb panel

aluminum honeycomb panel矫直工在交接班时先检查机械紧固件和液压传动系统，操作手柄及按钮是否正常。启动液压泵、电机是否正常。

根据铝单板型材长度，将后夹头的距离适当调整，并固定好后夹头，空负荷试车试行，操作钳口“开-闭”, cart“Stretching-Return”Several times, check whether it is normal, and make sure that the profile temperature is lower50℃Straightening can only be carried out at the same time, the loading operation jaw is loosened, the cart is returned to the limit position, and the rear chuck is in a straightened state when clamped at the same time.

The profile should be straightened in time to prevent the billet from accumulating on the cold bed, causing bruises, scratches and scratches. The decorative surface of the aluminum veneer profile should be upward to avoid scratches on the decorative surface. The conveyor belt conveying the straightened billet and the bridge belt should keep running synchronously.

在拉直过程中，用手掰动型材使其平直，或按动夹头旋转使型材平直，按Stretching手柄，Stretching开始，Stretching率应不大于1.5%, And pay attention to the change of the shape and size of the profile to avoid excessive stretching. After the stretching is over, the cart returns, loosen the front and rear chucks, and send the profile to the storage table.

You may not know about aluminum honeycomb panels, but in daily life more or less will come into contact with aluminum honeycomb panels. Aluminum honeycomb panels are widely used and are widely used in house decoration, elevators, rail transit, etc. Aluminum honeycomb panel is so magical, the next small series will take you to a trip to the popularization of aluminum honeycomb panel science tour.

Aluminum honeycomb panel is a typical representative of aerospace cutting-edge materials for civilian use. The intermediate interlayer contains air for heat insulation and sound insulation, and the density is very low, which can effectively reduce costs.

The wind pressure of aluminum honeycomb panel is stronger than that of aluminum veneer, because its internal structure is not easy to shear, so that the whole part is more stable. Experiments have confirmed that the sound insulation, heat insulation, heat preservation, and energy saving effects of aluminum honeycomb panels are very good. In this regard, aluminum veneer is no match. For example, raindrops hit the aluminum veneer, the sound is very loud, if it is aluminum honeycomb panel, the sound is very small.

Recommended article:

Aluminum honeycomb panel curtain wall installation process

/Article/lvfengwobanmuqiangan_1.html

Aluminum honeycomb panel is the preferred lightweight material for construction

/Article/lvfengwobanshijianzh_1.html

Basic common sense about honeycomb aluminum plate

/Article/guanyufengwolvbandej_1.html