China's earliest production and processing of aluminum veneer ceiling, one of the curtain wall manufacturers
Carved aluminum veneer introduction: Carved aluminum veneer refers to the building decoration material formed by processing after chroming and other treatments, and then using fluorocarbon spraying technology. Fluorocarbon coating mainly refers to polyvinylidene fluoride resin, divided into primer, topcoat, varnish three. The spraying process is generally divided into two coating, three coating or four coating.aluminum honeycomb panel
Fluorocarbon coating has excellent corrosion resistance and weather resistance, can resist acid rain, salt spray and various air pollutants, and has excellent cold and heat resistance,double curved plateCan resist strong ultraviolet radiation, can maintain long-term do not fade, do not powder, long service life. Carved aluminum veneer introduction
Carved aluminum veneer has the following characteristics
1, good fire resistance, with non-flammable.
2, with acid resistance, alkali resistance, UV resistance and other properties
3, lightweight, high strength, good rigidity.
4, good processing, strong plasticity, can be processed into various shapes
5. Strong stain resistance, easy to clean and maintain;
The spraying color is very rich and can meet various requirements in architectural design.
7, easy to recycle, environmental protection.
Introduction of carved aluminum veneer: The application field of carved aluminum veneer is very extensive, which can be used for curtain wall decoration and interior decoration such as airports, hospitals, subways, stadiums, art galleries, high-end clubs, entertainment venues, etc.
Carved aluminum veneer installation direction
1. Install and close the corners according to the same level.
2,carved plate按不同的要求有不同的骨架,如:L50*50*5mm角钢固定,预埋件铝挂件固定等,根据不同的产品有不同的固定方法。雕花铝单板的介绍
3. The hanging parts pre-installed on the keel of the gusset plate, together with the keel of the gusset plate, are tightly attached to the light steel keel in a vertical direction under the light steel keel. The spacing between the keel of the gusset plate is determined according to the size of the plate type, and must be adjusted to horizontal after all installation.
4. Buckle the gusset plate on the keel in sequence. After each piece is buckled, press down the inverted locking plate and connect the keel with the connecting piece when connecting. Carved aluminum veneer introduction
5. Gloves must be worn when installing the board surface. If fingerprints or stains are accidentally left, detergent can be used to clean and wipe dry.
Recommended:What are the advantages of carved aluminum veneer What are the advantages of carved aluminum veneer