Aluminum honeycomb panel with single curved surface

For the indoor aluminum honeycomb panel curtain wall decoration with single curved surface modeling, how to solve the disadvantages of the traditional aluminum plate processing and aluminum plate installation in the past, and foster strengths and circumvent weaknesses? At present, the more popular and fashionable decorative hanging process is to use molds to form aluminum honeycomb panels, with inner and outer arcs perpendicular to the installation surface, dense seam splicing installation, corner code unilateral locking, and the other side dislocation phase inserting and hanging firmly. The installation method can achieve straight, smooth, beautiful and generous lines, and realize the effect of truly circular arc-shaped aluminum plate shaping wall, which is much more beautiful than the assembly effect of small flat glass folding lines; it is a new product that replaces the traditional practice of the past.

This research system uses a number of single-surface arc-shaped aluminum plates formed by mold processing, and then welded and installed, which increases the smooth and beautiful lines compared with the assembly of small flat broken lines. It also reduces the stress concentration during material installation and keeps the finished product installed without deformation. At the same time, the angle code is staggered and inserted into the lock buckle, which can solve the effect of tight seam assembly. It has obvious advantages in the market competition, and the market prospect is broad, popular and beautiful.

Aluminum honeycomb panel is processed by mold for arc stretching, roll bending, lamination and compound forming. The panel folding is welded to install angle codes. The bottom surface is relatively reduced and the force point acts on the outer aluminum plate. The main facade is processed into a single-sided curved surface according to the design arc, and then the remaining hemming surface is processed into a design arc and welded into a unit aluminum plate by aluminum. Finally, it is continuously bolted and dry-hung, installed and formed, achieving a beautiful and generous effect.

Aluminum honeycomb panel is made of aluminum panel and bottom plate, plus two-component glue, the center is aluminum hexagonal honeycomb, vacuum composite. Aluminum honeycomb panel has a small density, greatly reducing the building load and cost, because the middle interlayer contains a lot of air, can sound insulation, heat insulation, no combustible substances, fire rating reached A2 level, waterproof, moisture-proof, no harmful gas release, unit mass than the strength, high stiffness, not easy to deformation, high flatness, good seismic performance, completely overcome the deformation of other decorative panels in a single large area, the middle of the collapse and other shortcomings. And the processing and application is convenient, can be arbitrarily cut and folded, the surface can be used in a variety of colors, including fluorocarbon coating can ensure long product life, and has the advantages of pressure resistance, large bearing load, light weight and recyclable. It is obvious that the superior force is better than the single-layer aluminum plate.

Recommended articles;

Process characteristics of honeycomb aluminum plate

/Article/fengwolvbandegongyit_1.html

Advantages of honeycomb aluminum sandwich structure

/Article/fengwolvbanjiacengji_1.html

Strengthening customer relations in the aluminum honeycomb panel market

/Article/jiaqianglvfengwobans_1.html