Production and processing difficulties of hyperbolic fluorocarbon aluminum veneer

For the aluminum veneer manufacturing industry, the hyperbolic fluorocarbon aluminum veneer has high cost, long production cycle, and is limited to the process and mechanical equipment, and may not be able to produce and process satisfactory Products. The key to the difficulties in the production and processing of hyperbolic carbon aluminum plates lies in two levels, one is the plate metal parts and the other is the paint spraying.

1. sheet metal parts

For sheet metal parts, the double curved plate is difficult to produce, process and form. To make the ideal hyperbolic fluorocarbon aluminum veneer, it is best to use 3 series aluminum substrate, its elasticity and production and processing indicators can ensure the final hyperbolic effect. There are many ways to make and process into hyperbolic, there are many articles on the Internet for professional discussion, the effect is better is a few, some production and processing up the difficulty coefficient is very large, difficult to operate.

2. spraying

In the process of painting, because the fluorocarbon aluminum veneer belongs to the non-traditional plate shape, if the application of electrostatic spray machine for painting, it is easy to cause uneven distribution of surface paint, the final actual effect is not good, need to manually spray paint.

Sheet metal materials, painting and so on need to spend a lot of manpower, which is the reason for its long production and processing cycle, therefore, to be able to mass production and processing of fluorocarbon aluminum veneer, and can promise short-term delivery, which is not credible.