Installation of Aluminum Honeycomb Panel

The beauty of the exterior wall of the building is inseparable from the decoration, and even more inseparable from the precise construction of the construction personnel, but for the troubledaluminum honeycomb panelThe problem of installation is technology. Many construction teams are not so familiar with the installation of aluminum honeycomb panels, so there are always problems like this or that after installation.

When installing the aluminum honeycomb panel, connect the hanger pre-installed on the triangular keel together with the triangular keel and the light steel keel in a vertical direction according to the plate spacing, then adjust the level to press the two sides of the square plate into the triangular keel seam in parallel, first install the aluminum veneer, then find a right angle at both ends in the transverse direction, and then pull a straight line to buckle the plates step by step.

每排扣完后要调整一次确保板面平整，铝单板板缝垂直。(Note that the direction of the small pit on the side of the square plate is inserted into the triangular keel seam.)Hoist the boom and light steel keel according to proper spacing

aluminum honeycomb panel吊杆间距小于或等于1.2m, light steel keel spacing is1.2Rice, wear gloves when installing aluminum trimming corner gussets according to the same level. If you accidentally leave dirty marks on the board surface, wash them with clear water. It is forbidden to tear off the protective film when installing aluminum veneer.

Recommended article:

Professional aluminum honeycomb panel manufacturer

/Article/zhuanyedelvfengwoban_1.html

Information about honeycomb aluminum sheet

/Article/fengwolvbandexianggu_1.html

Aluminum Honeycomb Panel Decorative Panel

/Article/lvfengwobanxuanzeyao_1.html