Production cycle of aluminum honeycomb panel

Production cycle of honeycomb aluminum plate

Honeycomb aluminum plate又称aluminum honeycomb panelAt present, it is the preferred decoration material for designers in the market. Aluminum honeycomb panel is a special customized product. Many people will care about its production cycle and whether it will affect the construction period. Today, I will talk to you about this topic.  First of all, I would like to talk about several factors that affect the production schedule of aluminum honeycomb panels:

① Specification type (if there are too many specifications, it will seriously affect the production cycle)

Whether the need to punch (if the surface of the aluminum honeycomb panel needs to be punched, especially the micro hole, then this will be very slow)

③ surface treatment (normal aluminum honeycomb panels are generally pre-roller coating, if you want to spray special colors such as: wood grain, stone grain, etc., it will seriously affect the production schedule)

④ Sheet shape (such as arc, curved surface production progress will be greatly reduced)

The daily output of some large manufacturers specializing in the production of aluminum honeycomb panels is as follows:

①平板1-3This specification (surface pre-roller coating) can produce about 2000 square meters a day without folding.

②平板1-3种规格（表面预辊涂）折边一天大约能生产1000Square left and right

③弧形一天最多只能50-100The square or so special will be more

According to normal specifications, the width shall not exceed 1.2 meters in length.4Mega1000A square production cycle is required.20Days or so, if it is arc-shaped then need45days or so. In fact, the production cycle is not slow, the main ordering cycle.7-15Every day. Therefore, if the construction period is relatively tight, the materials can be ordered in advance, so that the progress of the project will be greatly accelerated. Do not order aluminum honeycomb panels when the fire is imminent. The materials must be fixed first. If the fire is imminent before squeezing the production cycle of the manufacturer, the Products produced will be greatly reduced and the loss outweighs the gain. Chinese engineering should get rid of this bad habit.

Summary: In a word, it is better to be prepared for danger and do all the work well in advance than anything else.