Straightening method of aluminum honeycomb panel

　　您也许不了解aluminum honeycomb panelBut you can touch them in your daily life. Aluminum honeycomb panels are widely used in home decoration, elevators, and rail transit. With such a magic aluminum honeycomb panel, today\'s aluminum honeycomb aluminum panel manufacturers will take you to go to science once.

The aluminum honeycomb panel manufacturer will check whether the mechanical fasteners and hydraulic transmission system, operating handles and buttons are correct during shift change. Turn on the hydraulic pump and the motor is normal. According to the length of the aluminum veneer profile, properly adjust the distance between the rear chuck, fix the rear chuck, test run without load, open and close the pliers, and retract the cart several times to check whether it is normal. Before straightening, ensure that the temperature of the profile is below 50 ℃, then loosen the clamping with the jaws, return the cart to the limit position, and keep the straight state after clamping.

The section steel shall be straightened in time to prevent the accumulation of billets at the head of the cold bed from causing scratches, scratches and scratches. The decorative surface of the aluminum veneer profile shall face upward to avoid scratches on the decorative surface, and the blank conveyor belt shall be synchronized with the upper seat belt. When straightening, aluminum honeycomb panel manufacturers will straighten the profile by hand, or press the chuck to rotate to straighten the profile, and then start to lengthen according to the pull rod, the stretching rate cannot exceed 1.5, pay attention to the change of the shape and size of the profile, and avoid pulling the rear of the truck too large and backward; Release the front and rear chucks and place the profile on the storage table.