Honeycomb Aluminum Plate Installation Process, Honeycomb Aluminum Plate Installation Precautions

　　Honeycomb Aluminum Plate Installation Process, Precautions for Honeycomb Aluminum Plate Installation | Kaimai Information | Kaimai Metal Building Materials

　　Honeycomb aluminum plateWith its simple structure and strong three-dimensional sense, it has been loved by the majority of consumers. In order to ensure its effect, we need to understand its installation process.

1. setting out positioning:

1, according to the design height of the ceiling finish surface pop-up ceiling installation contour line;

2. Pop up the distribution line of the main keel according to the spacing of 1000~1200mm;

2. installation of light steel main keel:

Install the light steel dragon on the hanger rod through corresponding pendants, connect two adjacent keels with connectors, stagger the positions of two adjacent rows of keels, and adjust to horizontal and straight after installation.

3. installation boom:

Punching holes according to the positioning points of the lifting points, installing expansion bolts and suspenders, and installing light steel keel pendants on the suspenders. If the hanger rod cannot be installed at the corresponding position due to the influence of internal equipment, the angle steel bridge shall be welded and the hanger rod shall be installed at the corresponding angle steel position.

4. installation of honeycomb panels:

Determine the installation axis of the ceiling and install it in the corresponding order starting from the axis. The honeycomb panel can adjust the height and horizontal straightness of the boom by itself, which is convenient for installation, and is especially suitable for large-area horizontal installation.

When installing the honeycomb panel, the honeycomb panel can be installed by adopting the above installation method, and its effect will be very good. So if you are in the process of installing the honeycomb panel, encountered some intractable diseases.

Next, honeycomb panel manufacturers to share with you, in the installation of honeycomb panels, the need to pay attention to matters, you can serve as a reference!

1. the installation of metal honeycomb panel, do not use the glide, because the slide inside after regular use, not easy to clean, but also water.

2., if there is no door frame, a water-blocking door stop should be installed, and a special threshold stone should be installed, which should be 1.5cm -2cm higher than the ground.

3., floor tiles and wall tiles should be laid first, and then high compartments in the toilet should be customized according to the actual size. Attention should be paid to the error problem of the wall surface. High compartments can only be customized according to the actual size of the site.

4. the installation of metal honeycomb panels, the process needs to be more sophisticated, if the bathroom high compartment installation is not when, it will lead to the toilet drainage system is not smooth and some serious problems.

After reading the above introduction, I believe you have some understanding of this, so we need to pay attention to some matters when installing metal honeycomb panels, then you can use it as a reference.