China's earliest production and processing of aluminum veneer ceiling, one of the curtain wall manufacturers
aluminum honeycomb panelThe straightener shall first check whether the mechanical fasteners and hydraulic transmission system, and whether the operating handles and buttons are normal. Check whether the hydraulic pump and motor are normal.
根据铝单板型材长度,将后夹头的距离适当调整,并固定好后夹头,空负荷试车试行,操作钳口“开-闭”, cart“Stretching-Return”Several times, check whether it is normal, and make sure that the profile temperature is lower50℃Straightening can only be carried out at the same time, the loading operation jaw is loosened, the cart is returned to the limit position, and the rear chuck is in a straightened state when clamped at the same time.
The profile should be straightened in time to prevent the billet from accumulating on the cold bed, causing bruises, scratches and scratches. The decorative surface of the aluminum veneer profile should be upward to avoid scratches on the decorative surface. The conveyor belt conveying the straightened billet and the bridge belt should keep running synchronously.
在拉直过程中,用手掰动型材使其平直,或按动夹头旋转使型材平直,按Stretching手柄,Stretching开始,Stretching率应不大于1.5%, And pay attention to the change of the shape and size of the profile to avoid excessive stretching. After the stretching is over, the cart returns, loosen the front and rear chucks, and send the profile to the storage table.
Recommended article:
What material does the aluminum honeycomb panel decorative panel consist
/Article/lvfengwobanzhuangshi_1.html
Mechanized production of aluminum honeycomb panels
/Article/zhuanyedelvfengwoban_1.html
Mechanized production of aluminum honeycomb panels
/Article/zhuanyedelvfengwoban_1.html